Tepco announces latest nuclear accident analysis results

According to reports, the latest analytical results of the nuclear reactor at the Fukushima Daiichi nuclear power plant were recently announced. Within four to 77 hours after the earthquake, the furnace cores of nuclear reactors No. 1-3 began to suffer varying degrees of damage.

According to the “Yomiuri Shimbun” report of Japan, on March 12, Tokyo Electric Power Company announced the latest analytical results of nuclear reactor core status after the accident at No. 1 and No. 3 reactors of the Fukushima Daiichi nuclear power plant.

This assessment test was originally published in May 2011. However, because the value of the nuclear reactor's pressure was found to be inconsistent with the actual measured value, the report was then overturned and reanalyzed.

From the analysis results, it is known that the damage of No. 1 reactor pressure vessel occurred at about 1:50 am on March 12, 2011, and it took approximately 11 hours from the “3.11 earthquake”. This analysis result is higher than the previous one. The result was 4 hours earlier. The damage to the hearth occurred four hours after the earthquake and was the same as the previous analysis. However, the time for all the fuel to dissolve was 9 hours after the earthquake, which was 6 hours earlier than the previous analysis. .

The damage time of the hearth of reactor No. 2 was the same as that of the last analysis. It occurred 77 hours after the earthquake. The damage of reactor No. 3 occurred after 44 hours after the earthquake. The result was 2 hours late.

Fast Recovery Diode (FRD) is a kind of semiconductor diode with good switching characteristics and short reverse recovery time. It is mainly used in electronic circuits such as switching power supply, PWM pulse width modulator and inverter, as high frequency Rectifier Diode. Use for freewheeling diodes or damper diodes. The internal structure of the fast recovery diode is different from that of a normal PN junction diode. It belongs to a PIN junction diode, which adds a base region I between the P-type silicon material and the N-type silicon material to form a PIN silicon wafer. Since the base region is thin and the reverse recovery charge is small, the reverse recovery diode has a short reverse recovery time, a low forward voltage drop, and a high reverse breakdown voltage (withstand voltage value).

Fast Diode

Fast Diode,Fast Recovery Rectifier Diode,Fast Recovery Diode,Fast Switching Diode

Dongguan Agertech Technology Co., Ltd. , https://www.agertechcomponents.com